JRready ST5262 2Pcs Molex Micro Fit Extractors Microfit Terminal Release Tool Kit for Molex MX3.0 Male/Female Terminals Microfit 3.0 Extraction Tool for Micro-Fit Terminals Pin Removal Tool Kit

After having more than a few connectors fail (bad crimps, totally my fault) and just chopping them off and replacing them I finally ordered a set of these and my goodness I should have done it years ago. They work flawlessly and are so easy to use. Insert and press the plunger. Since purchase I have saved the cost of these twice over in what I paid for molex fittings. The included cars are nice for storage, while made of metal I don't trust the small tines at the ends just free floating in a work bag or toolbox. Overall of you do anything with molex! Don't do it without these.

If you work with circuit boards that use Micro Molex connectors and need to be able to de-pin connectors these are the best. High quality, precision fit, and with the ejector pin these are the best for the job. They make pin removal as easy as possible. If used correctly and once you get the hang of it you can de-pin a 12 pin connector in probably a minute or two without a problem. Highly recommend.

Works Great

Bought for working around the house & automotive repairs. I have not needed to use it yet but appears to be well made and a good value for your money.

I struggled for a week with crappy tools made with poor tolerances and shoddy metal because I didn't know better. I finally gave up and bought this tool. Aside from one pin which I believe was damaged by the previous crappy pins this tool knocked that pin out in 2 seconds with a satisfying click. If I had bought this tool from the beginning I would have been done weeks ago.

I found out about this product via a recommendation and is worth every penny. I have the original MicroFit Molex pin extractor and it bends every time I was using it making hard to extract the pins. When I started using the JRready it became so easy to extract the pins that jobs that will take me 10 minutes now takes me less than 2 minutes. Is a most have tool for anyone that work with MicroFit Molex adapters.

Little difficult to use, takes a while to figure it out

Excellent product. Would recommend. A must when working with Molex connectors. They work well for the intended connector types.

so i got a set of these and so far so good took a bit of getting use to to use and first i used the male one in a female molex terminal and a female in the male one but once i got on to using then they ejected the terminal pins good but they do look very fragile so be careful not to jam them in or bend them once thier in the pcie connector cuz u will break them but i will def recommend them

What can I say more than has been already said: inexpensive and they work like a charm. If you work a lot with Molex MFT3.0 connectors, you want those. Buy them!

Ensure that you get the right ones for the right pins. These do more, but I bought them for the Molex™️ 3.0 series pins. They saved me a LOT of grief when building new cables and getting the pinout wrong at first. I was a klutz at first, so I need replacement tips for the female tool. Oh speaking of which, figure out which is for female and which for male and use appropriately, hint hint.

I bought this after spending hours making and using my own contraption to depin Molex 3s. This took several seconds. Even if I don't use it again it was well worth its price.