Buyers Products FS2797CH Large Chrome-Plated Folding Step For Emergency Vehicles, 6.75 x 8.56 Inch Platform, Conforms to NFPA Regulations, Bolt-On Mounting, Step For Vehicle

This is the best truck step. Very solid plus in and out very easy. Not slick and doesn't give.

I used this to provide a second high step into the 8 ft bed of my F350. I installed it 5 inches behind my fuel refill door. I cut grey trex decking material available at Lowes to reinforce the panel. I made a U shaped bracket with the trex and screws that was 4 7/16 wide so that it would fit very snugly between the truck bedliner steel and the door panel then placed stainless steel screws to hold in place from the bedside. Then I made a trimmed edge paper template for the screw holes for the folding step and drilled a very small pilot hole to make sure it was at the right edge location. Then using gradually increasing size of the drill bits I enlarged the door panel holes up to 5/16 size. This step was important because if the holes are not very exact you will have problems threading the bolt. I then placed four 8 inch long 5/16 inch galvanized carriage bolts thru the folding step after I glued the soft washer plate in place. As the bolt travelled thru the trex U bracket I added galvanized washers and bolts and two flat steel reinforcement plates I had drilled out with 3/8 holes to further stiffen the support. I cut off about 1 1/2 inch of the bolts before adding a cap nut to each at the inside of the truck bed. I also had to purchase an extra long 5/16 inch metal drill bit. After tightening down all the bolts, the step can take my 180 pound weight without causing any flexion of the exterior wall panel of the truck. I have attached install photos.

Good product and fast shipping

Extremely sturdy. very positive position locking, large platform and very grippy.

Very solid heavy duty step. Packing/packaging should be more sturdy but this could be UPS handling issue. The spring (open/close) action is really stiff & really hard to open & close. Needed to use a padded table vice to hold it down to open/close...Nice sturdy step but needs smoother folding/unfolding to avoid damage to truck mount location.

This is a great step up. It is heavy and seems heavy duty. It is a little hard to open and close. We put a good dose of grease in it and I can raise and lower it with my hands. The "diamond teeth" on top of it are sharp and will cut you. I will put a thin rubber layer on mine to keep it from hurting my feet when I get up and down from the bed in my gooseneck horse trailer. I would have given 5 stars if the "teeth" weren't so sharp.

Almost impossible to open. Built off

Makes getting in/out of the skid loader much easier! Very heavy duty step. Bought one for each of my loader buckets.

Probably made to well & weighs a heap. The spring is that tight that its impossible to pull down & be used as a foldable step, therefor not fit for purpose & the weight is an issue at around 4klgs. Wouldnt reccomend

Fixé à mon camion

Great product, great quality. Exactly what I wanted.

The item is so tight I could not open it without using tools!